Kingston ValueRAM 4GB (2x2GB) DDR3 1333MHz Non-ECC 240-pin DIMM Memory Module

£25.99 includes FREE UK Postage (other delivery options available)

Shipping Destinations for this item

UK - Shipping Included
United Kingdom
Europe Zone 1 - £1.29
Austria, Belgium, Denmark, France, Germany, Ireland, Luxembourg, Netherlands, Switzerland
Europe Zone 2 - £1.49
Andorra, Croatia, Czech Republic, Finland, Liechtenstein, Monaco, Norway, Poland, Sweden
Europe Zone 3 - £1.79
Bulgaria, Cyprus, Estonia, Faroe Islands, Gibraltar, Greece, Greenland, Hungary, Iceland, Italy, Latvia, Lithuania, Malta, Montenegro, Portugal, Romania, San Marino, Serbia, Slovakia, Slovenia, Spain, Vatican City
North America - £1.49
Canada, USA
Australia and Far East Asia - £1.49
Australia, Israel, New Zealand, Taiwan
Japan - £1.49
Japan
Others - £1.79
Falkland Islands

RRP £0.00

Sorry, this product is currently unavailable.

General

Marketing

ValueRAM's KVR1333D3S8N9K2/4G is a kit of two 256M x 64- bit (2GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8 memory modules, based on eight 256M x 8-bit FBGA components per module. Total kit capacity is 4GB. The SPD's are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers.

Warranty

Lifetime

Barcode

740617193602

Memory

Memory Size

4096MB (2 module(s) x 2048MB)

Memory Type

DDR3

Memory Speed

1333MHz

Memory Package

DIMM

Pin Configuration

240 pins

Bus I/O Configuration

Unbuffered

Error Correction

Non ECC

CAS Latency

CL9

Connector Material

Gold

Module Configuration

256M x 64

Electrical

Voltage

1.5V

Environmental

Operating Temperature

0 to 85?C

Non Operating Temperature

-55 to +100?C

Features

  • JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
  • VDDQ = 1.5V (1.425V ~ 1.575V)
  • 667MHz fCK for 1333Mb/sec/pin
  • 8 independent internal bank
  • Programmable CAS Latency: 9, 8, 7, 6
  • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
  • Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
  • 8-bit pre-fetch
  • Burst Length: 8 (Interleave without any limit, sequential with starting address ?000? only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
  • Bi-directional Differential Data Strobe
  • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ? 1%)
  • On Die Termination using ODT pin
  • Average Refresh Period 7.8us at lower than TCASE 85?C, 3.9us at 85?C < TCASE < 95?
  • Asynchronous Reset
  • PCB : Height 1.18 inch (30mm), single sided component


For more information and our Delivery Policy see here.


For more information and our Returns Policy see here.

Catalogue No: EL-23200106